MacDive Forums

Posted: **Mon Feb 04, 2013 5:42 am**

Macdive does not display the correct temperature when downloaded from the Aeris Elite T3 - its usually either 10-20F too high or too low. No idea why. The temperature displays correctly on the computer and when downloaded with Aeris software.

Secondly, Macdive does not seem to record the end PSI (or any time after the first 5 minutes). It always gives a value of 0 PSI... The PSI data and end PSI number is downloaded correctly with the Aeris software. Any idea how to get these data into Macdive???
Thanks!

Posted: **Mon Feb 04, 2013 5:44 am**

This issue is resolved in the next version of MacDive (due out shortly).

Sorry for the inconvenience. This was due to a slightly newer version of the T3 that MacDive wasn't aware of.

Posted: **Mon Feb 04, 2013 5:48 am**

nick wrote:This issue is resolved in the next version of MacDive (due out shortly).

Sorry for the inconvenience. This was due to a slightly newer version of the T3 that MacDive wasn't aware of.

Great - thanks for the quick response!

Posted: **Mon Feb 04, 2013 5:50 am**

No problem. If you like, you can follow the instructions here:

viewtopic.php?f=5&t=407

Using the "atom2" test. I can verify your data all downloads as expected before releasing the new version.

MacDive Forums

Problems with Temp and PSI with Aeris Elite T3

Problems with Temp and PSI with Aeris Elite T3

Re: Problems with Temp and PSI with Aeris Elite T3

Re: Problems with Temp and PSI with Aeris Elite T3

Re: Problems with Temp and PSI with Aeris Elite T3