Macdive does not display the correct temperature when downloaded from the Aeris Elite T3 - its usually either 10-20F too high or too low. No idea why. The temperature displays correctly on the computer and when downloaded with Aeris software.
Secondly, Macdive does not seem to record the end PSI (or any time after the first 5 minutes). It always gives a value of 0 PSI... The PSI data and end PSI number is downloaded correctly with the Aeris software. Any idea how to get these data into Macdive???
Thanks!
Problems with Temp and PSI with Aeris Elite T3
-
nick
- Site Admin
- Posts: 4376
- Joined: Sat Apr 12, 2008 8:33 am
- Dive Computer: Shearwater Teric
- Contact:
Re: Problems with Temp and PSI with Aeris Elite T3
This issue is resolved in the next version of MacDive (due out shortly).
Sorry for the inconvenience. This was due to a slightly newer version of the T3 that MacDive wasn't aware of.
Sorry for the inconvenience. This was due to a slightly newer version of the T3 that MacDive wasn't aware of.
Re: Problems with Temp and PSI with Aeris Elite T3
nick wrote:This issue is resolved in the next version of MacDive (due out shortly).
Sorry for the inconvenience. This was due to a slightly newer version of the T3 that MacDive wasn't aware of.
Great - thanks for the quick response!
-
nick
- Site Admin
- Posts: 4376
- Joined: Sat Apr 12, 2008 8:33 am
- Dive Computer: Shearwater Teric
- Contact:
Re: Problems with Temp and PSI with Aeris Elite T3
No problem. If you like, you can follow the instructions here:
viewtopic.php?f=5&t=407
Using the "atom2" test. I can verify your data all downloads as expected before releasing the new version.
viewtopic.php?f=5&t=407
Using the "atom2" test. I can verify your data all downloads as expected before releasing the new version.