MacDive Forums

Hi

I failed to import data from my Suunto Vyper computer.

I have OSX Mountain Lion 10.8.1
I have original USB connector (though I am not 100% sure which way to connect it, I tried both directions).
I installed FTDI USB driver.
The serial port is create - /dev/tty.usbserial-ST000001
The device is recognized in System Information:

Suunto Sports Instrument:

Product ID: 0xf680
Vendor ID: 0x0403 (Future Technology Devices International Limited)
Version: 4.00
Serial Number: ST000001
Speed: Up to 12 Mb/sec
Manufacturer: Suunto
Location ID: 0x04100000 / 4
Current Available (mA): 500
Current Required (mA): 300

I keep getting the error: "Failed to read header information" , error code -5 in MacDive 2.1.5, and -7 in MacDive 2.1.6

Cheers
Michal

Hi,

Take a read of Troubleshooting Downloads in the help, but first, I'd check that the device is in PC Transfer Mode, and doesn't have low battery.

Hi

It is in PC transfer mode and does not have low battery.

I read Troubleshooting but the only suggestion I found is that it might be not properly connected.

Cheers
Michal

Hi

Any ideas? I just tried one more time but failed again.

Will appreciate any hints..

Cheers
Michal

./vyper /dev/tty.usbserial-ST000001
DATETIME 2012-09-13T15:59:31Z (1347551971)
REVISION 6242978fc010b1bc59e001209f8a4ebe0432e102
DEVICE=/dev/tty.usbserial-ST000001, DELAY=500
suunto_vyper_device_open
Configure: baudrate=2400, databits=8, parity=2, stopbits=1, flowcontrol=0
Timeout: value=1000
DTR: value=1
Sleep: value=100
Flush: queue=3, input=1, output=0
device_foreach
Sleep: value=500
RTS: value=1
Write: timer=1, size=5, data=0500161407, remaining=0
Sleep: value=200
Flush: queue=1, input=0, output=0
RTS: value=0
Read: timer=1001, size=0, data=, remaining=0
../../source/src/suunto_vyper.c:253: Failed to receive the answer.
../../source/examples/suunto_vyper_test.c:47: Cannot read dives.
suunto_vyper_device_open
Configure: baudrate=2400, databits=8, parity=2, stopbits=1, flowcontrol=0
Timeout: value=1000
DTR: value=1
Sleep: value=100
Flush: queue=3, input=0, output=0
device_dump
Sleep: value=500
RTS: value=1
Write: timer=1, size=5, data=0500002025, remaining=0
Sleep: value=200
Flush: queue=1, input=0, output=0
RTS: value=0
Read: timer=1000, size=0, data=, remaining=0
../../source/src/suunto_vyper.c:253: Failed to receive the answer.
../../source/examples/suunto_vyper_test.c:82: Cannot read memory.

SUMMARY
-------
test_dump_sdm: Timeout
test_dump_memory: Timeout

Have you read the help? For starters, is this device in transfer mode?

Hi

The device was in transfer mode.

Anyway, I gave up and send the cable back :/

Cheers
Michal