Fail to oimport from Mares Puck Air into Mac Dive 2.0

[MikeHoffmann]

Hello

i tried hard to import any dives from my Mares Puck Air into Mac Dive 2.0 . If have a registered version but it still failed. If have set the Port to/dev/tty.SLAB_USBtoUART.
I have installed the driver Silicon Labs CP210x drive as rquired

Mac Dive dowloaded about 25 % and then show me the Import Error :"Failed to read dive computer menory (Error Code: -5 ).

Can any one help me.
Thanks in advance

Mike

[nick]

Can you try to follow the instructions from here:

http://www.mac-dive.com/forum/viewtopic.php?f=3&t=14

(Third post)

But replace "vyper2" with "puck" ?

And then email me PUCK.LOG (and PUCK.DMP if it exists) afterwards ?

[MikeHoffmann]

Hi SiteAdmin

i send you the files via Email.

I tried again to import from Puck Air and now i get 99 % and an Error Code -3 .

Maybe this helps you ti figure out the mistake.


Mike

[nick]

Ah - this is actually a Puck Air (which we've not looked at, so isn't technically supported). The transfer seems fine, but we'll take a look at getting it working for the next release.

[TnT]

Support for the Puck Air is added to the libdivecomputer project. I'm sure Nick will include it in the next macdive release.

[Andy72]

Hi all

I have downloaded the trial version, but can't sync my mares puck air. I always get the error as mentioned in the post above. Is there anyone here that can help me to make it work? Very interested to buy the software, but before that i should be sure that it works.

Thanks for your help in advance
Andy


Finally it works... Programm looks good

[nick]

Hello, so is this working?