Importing Dives from Suunto Dive Manager 3.1.0

[Joe]

Hi,

I have just brought MacDive 2.0.4 and am loving it.

I just one one problem when I download my dives from my Suunto Viper I'm only getting 56 out off 279. I know the memory on the Suunto's is low and new dive over rights the old ones. I have all my dive already on the Suunto software (Dive Manager 3.1.0) Is there a way I can transfer them to MacDive 2.0.4?

I have tried exporting them as .SDE, .CSV, .ZXL and .ZXU but when I drag and drop on MacDive is doesn't see them. I have also tried the Backup Database but again MacDive doesn't see it.

Please help as I would like to have all my dives in one place.

Thanks
Joe

[Joe]

All sorted, I think I was exporting the file wrong tried it again and it worked fine.

Sorry


I do have some comment:-

In the Gear/Tank it would be good to have a pull down menu with, Single, Twins, Pony, Stage Cylinders. If you have twins it would also be good to have two serial number columns so I can put both cylinders in. you could also have a pull down with alloy or steel cylinder as I have twin 7s, 10s and 12s steel with alloy and steel stages.

Also could you use the computers clock so you could have reminders when your cylinders/reg are up for service? Nitrox Service (required every year), Visual Check (every two and half years) and Hydrostatic Test (every five years)

And one last thing I cant seem to put anything in the working pressure.

Thanks
Joe

[nick]

Working Pressure can only be changed if you are using imperial units. It is disabled if you are using metric.