MacDive Forums

I have been able to download dives for a long time without any problems. When I upgraded to 2.1.0 I suddenly lost the ability to download dives from my Suunto.

What would usually happen before 2.1.0 was this:

1. I would select Download Dives - and click the button after I had selected the computer.
2. It would fail once.
3. Then I would do it again, and it would import the dives I wanted to.

Now it fails all of the time with this error:

http://d.pr/y7I4

MacDive used to put this computer into PC-TR mode for me - and I can't figure out how to get it to that mode myself. I have looked through the manual a ton - can't seem to find it.

Any ideas what I can do to fix this? Could it be the cable?

I am running Lion and have installed the drivers.

Thanks for any help you guys can offer.

The Vyper Air should do this automatically, I think.

Is your battery low?

Don't think so - it's only about 6 months old - I will check that tonight.

If not, just give it a couple of imports. Sometimes these devices don't "wake up" properly and a second import will do the trick.