Failed to read header information (Error Code: -5) - battery
Posted: Mon Jul 11, 2011 10:28 pm
Hi,
after running into the above error and searching through the forum, I tried the different trouble shooting steps to no avail.
The light on the cable gave a short green flash, on the display of my Suunto two arrows blinked shortly, but then the error hit again each time I tried.
What ultimately turned out to be the problem is the little battery icon at the bottom of my Suunto's screen..... indicating that the battery is too low to communicate via serial port.
So if you can't connect, maybe it is just the battery of your dive computer running on empty.
after running into the above error and searching through the forum, I tried the different trouble shooting steps to no avail.
The light on the cable gave a short green flash, on the display of my Suunto two arrows blinked shortly, but then the error hit again each time I tried.
What ultimately turned out to be the problem is the little battery icon at the bottom of my Suunto's screen..... indicating that the battery is too low to communicate via serial port.
So if you can't connect, maybe it is just the battery of your dive computer running on empty.