MacDive Forums

Hello,

I have recently purchased Mac Dive and must say I am very pleased with it so far, bar one area (excuse the pun!)
I have successfully managed to import my dives (nearly 400) from Suunto Dive Manager, however a lot of the air data which I manually added (not having an air integrated computer) has been lost.

I still have it written in my paper log, and would like to re–add if possible, however I cannot seem to find a way to manually add in air at the start and end along with cylinder size.

Also can the program cope with changing cylinders

If not will this functionality be added in a future release?

Regards,

Olly

For cylinder size, add a tank and set the size.

For air start/end, edit it directly in the dives table or in the dive inspector.

Thanks, will give it a go later.
I knew it was something obvious!

Thanks

Olly

Right, thanks I have worked out how to add a cylinder and set the air (start and end).

My next question, is how can I add the air figures for a secondly cylinder? I have added a stage cylinder to the gear list for the dive, but cannot see where to add the second set of air figures? Or is this functionality not yet available?

Otherwise on dives with gas switches my SAC rate will be calculated as much less than actual.

Cheers

Olly

Multi gas support is on the todo list but not yet done.

Brilliant, Thanks!

Olly