Hey All,
I am using a Oceanic VT3, Cable supplied by oceanic. I have macdive 1.5.3.
I cant seem to get the computer to read the dive computer and comes up with message "Error contacting dive computer"
Computer is in countdown mode.
Please help! Im going to go nuts if i cant get it to work!
VT3 Macdive Help
- nick
- Site Admin
- Posts: 4363
- Joined: Sat Apr 12, 2008 8:33 am
- Dive Computer: Shearwater Teric
- Contact:
Re: VT3 Macdive Help
You can try following the troubleshooting instructions for MacDive2, but 1.5.3 isn't supported any longer. Make sure you have installed a USB driver.
See http://www.mac-dive.com/help/ under Importing. The VT3 should work fine, though there are a few bugs with Oceanic devices in that version (in terms of decoding the data).
See http://www.mac-dive.com/help/ under Importing. The VT3 should work fine, though there are a few bugs with Oceanic devices in that version (in terms of decoding the data).
-
- Posts: 2
- Joined: Fri Sep 24, 2010 6:08 am
- Dive Computer: VT3
Re: VT3 Macdive Help
The oceanic site only has drivers for WINDOWS
I have tried installing a different driver but with no luck. Any suggestions?
I have tried installing a different driver but with no luck. Any suggestions?
- nick
- Site Admin
- Posts: 4363
- Joined: Sat Apr 12, 2008 8:33 am
- Dive Computer: Shearwater Teric
- Contact:
Re: VT3 Macdive Help
My website has links to the Mac driver. So does the troubleshooting page:
http://www.mac-dive.com/devices.phpMacDive Supported Devices wrote: Please see the supported devices page on the MacDive website for a current list of http://www.mac-dive.com/devices.php and which drivers to use.