Visibility auto entries

General MacDive discussion, updates, etc.
Post Reply
alanl50
Posts: 4
Joined: Thu Jul 21, 2016 12:24 am
Dive Computer: Suunto Vyper 2

Visibility auto entries

Post by alanl50 »

When I am entering visibility in the Dive Inspector (Mac OS) it tries to automatically bring up previous entries. It will not allow me to enter a different entry. For example, I had 20 feet in a previous entry. When I try to enter 2 feet (yes it was actually that bad) it keeps bringing up the previous 20 feet entry, and even when I delete the 0 it brings it back. I know that this is a 'feature' to recall previous entries to make it easier to enter, but I can't seem to figure out how to make the new entry.

Your help would be appreciated.
User avatar
nick
Site Admin
Posts: 4341
Joined: Sat Apr 12, 2008 8:33 am
Dive Computer: Shearwater Teric
Contact:

Re: Visibility auto entries

Post by nick »

When the 0 appears just press Delete on your keyboard.
alanl50
Posts: 4
Joined: Thu Jul 21, 2016 12:24 am
Dive Computer: Suunto Vyper 2

Re: Visibility auto entries

Post by alanl50 »

When I hit delete, to remove the 0 it just reenters it again. It will not allow me to change it.

Using Mac OS 10.15.6
User avatar
nick
Site Admin
Posts: 4341
Joined: Sat Apr 12, 2008 8:33 am
Dive Computer: Shearwater Teric
Contact:

Re: Visibility auto entries

Post by nick »

The other workaround is to type it somewhere then just paste it in. Which is stupid, but should work. The auto complete sucks.
alanl50
Posts: 4
Joined: Thu Jul 21, 2016 12:24 am
Dive Computer: Suunto Vyper 2

Re: Visibility auto entries

Post by alanl50 »

I finally figured it out. The auto entry was 20 to 30 feet. to change this to 2 to 3 feet I had to delete everything after the 2 and then reenter the rest.

Thanks for your help.
Post Reply