Page 1 of 1
Air model incorrectly defaults back to AIR
Posted: Thu Aug 05, 2010 11:27 pm
by detlevski
I have a Vyper which is always in Gauge mode, everytime I import my dives it defaults back to Gauge mode.
Is there anything I can do ?
Re: Air model incorrectly defaults back to AIR
Posted: Thu Aug 05, 2010 11:42 pm
by nick
If your vyper is in gauge mode, then that's what they will import as.
I'm afraid I don't quite understand the problem - your thread title is saying the gas model incorrectly defaults to air, but here you say it's always in gauge. Could you perhaps clarify exactly what is wrong for me?
Re: Air model incorrectly defaults back to AIR
Posted: Fri Aug 06, 2010 12:18 am
by detlevski
It doesn't import the dive as made in "Gauge" mode, maybe it should but it doesn't.
Or do you mean I have to set it manually, I thought the GAS-model was part of the data of a dive.
If the latter is the case then the import is not correct.
Re: Air model incorrectly defaults back to AIR
Posted: Fri Aug 06, 2010 12:25 am
by nick
Can you please follow the instructions here:
http://www.mac-dive.com/forum/viewtopic.php?f=5&t=407
And send me the resulting .DMP file. Sounds like an import problem.