Ratio Computer iX3M Reb
Posted: Sun Apr 16, 2017 11:29 pm
Hi There,
Just starting to use a Ratio Computer iX3M Reb. It works fine with Mac-Dive but I have few questions/remarks:
1) The outside temperature is not in MacDive. I have the same issue with a Suunto D9TX, a Shearwater Perdix, Petrel but not with a Suunto D6.
2) While merging 2 dives on Air, the gas for the second tank (i.e. second dive) has been set to 10/60. Note that this dive was on gauge mode.
3) This computer has a built-in GPS that I didn't use yet. Will it be possible to get the GPS position of the dive in MacDive during the upload?
4) Will it be possible to get the Gradient factors that go with the decompression model? That work for none of my dive computers but that would be lovely to get those parameters.
By the way, I didn't check the Bluetooth...
Many thanks for the great job you did with MacDive.
Yvan
Just starting to use a Ratio Computer iX3M Reb. It works fine with Mac-Dive but I have few questions/remarks:
1) The outside temperature is not in MacDive. I have the same issue with a Suunto D9TX, a Shearwater Perdix, Petrel but not with a Suunto D6.
2) While merging 2 dives on Air, the gas for the second tank (i.e. second dive) has been set to 10/60. Note that this dive was on gauge mode.
3) This computer has a built-in GPS that I didn't use yet. Will it be possible to get the GPS position of the dive in MacDive during the upload?
4) Will it be possible to get the Gradient factors that go with the decompression model? That work for none of my dive computers but that would be lovely to get those parameters.
By the way, I didn't check the Bluetooth...
Many thanks for the great job you did with MacDive.
Yvan