Page 1 of 1

Perdix Multiple Cylinder Pressures / Other Comments

Posted: Mon Jul 17, 2017 11:32 pm
by TheTrickster
Just download the iOS App - and for sure its the best iOS based dive log app I've used.

I hope this is the right place to post comments.

1. Can we enable multiple photo attaching, one by one is a bit of a drag
2. Can you extract the GPS location from where photos were taken?
3. Could you show/overlay on the photo slideshow page(s) any of the EXIF data (shutter / aperture / iso?) - and also an approximate depth (obviously based on if the camera is set to the same time/date as the PDC)
4. I'm using the Perdix Ai on my CCR, it appears to be only transferring the cylinder pressures on one of the transmitters, would be great to see both, especially when it comes to the end of the week and we have to reconcile our gas bill!
5. Did I see a post about where to list scrubber duration?

Thanks again, really great App.

Rich

Re: Perdix Multiple Cylinder Pressures / Other Comments

Posted: Tue Jul 18, 2017 4:57 am
by nick
1. Can we enable multiple photo attaching, one by one is a bit of a drag
You can do this in the macOS version.
2. Can you extract the GPS location from where photos were taken?
The macOS version can do this (but only to set on the current site).
3. Could you show/overlay on the photo slideshow page(s) any of the EXIF data (shutter / aperture / iso?) - and also an approximate depth (obviously based on if the camera is set to the same time/date as the PDC)
If you auto-add on the macOS version you will get events on the profile which serve to show the depth a photo was taken.
4. I'm using the Perdix Ai on my CCR, it appears to be only transferring the cylinder pressures on one of the transmitters, would be great to see both, especially when it comes to the end of the week and we have to reconcile our gas bill!
This is not yet supported.
5. Did I see a post about where to list scrubber duration?
Yes, probably. Go to the gas details tab and tap on the "dive computer/weights" bit at the top. It's a bit obscure.

Re: Perdix Multiple Cylinder Pressures / Other Comments

Posted: Tue Jul 18, 2017 12:24 pm
by blindmonkee
nick wrote: This is not yet supported.
The key word there being "yet"? :D